Ritron " 6 " SERIES OUTPOST Technické informace Strana 21
- Strana / 23
- Tabulka s obsahem
- ŘEŠENÍ PROBLÉMŮ
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
TROUBLESHOOTING
Have questions? Call
800-USA-1-USA
(800-872-1872) or visit our website at www.ritron.com 18
NOTES
1. • Try a battery pack from a working radio. If the radio in question works with
that pack, the original battery is suspect.
• Charge the suspect battery as recommended in this manual. If this original
battery cannot power the radio, try charging it again with another charger. If
the battery still doesn’t hold a charge, the pack should probably be replaced.
• If the battery appears to be ‘good’ after using the second charger, the first
charger may be faulty. Contact a dealer or Ritron about an accessory that is
not operating property.
2. • Reception can often be improved if you relocate by a short distance. This
effect is more noticeable inside buildings.
• The range for JMX radio is about two miles, line-of-sight.
3. If your radio does not detect calls from other radios on the channel, turn off
Quiet Call by pressing and holding both volume buttons at the same time—a
double beep indicates Quiet Call is off.
4. • Without use of a repeater
. To hear a call, select a channel programmed to
receive the caller’s transmit frequency. To call another unit, select a channel
programmed to transmit the other radio’s receive frequency.
• Using a repeater
. A radio channel can hold two separate operating
frequencies, one for receive and one for transmit. Your channel must work
with the repeater’s transmit and receive frequencies.
5. • Maximum power drain occurs when the radio transmits, so don’t hold down
the PTT more than needed to transmit.
• Battery power is used while the handheld is left on to receive calls. If
practical, switch off the unit.
6. • Battery capacity is greatly reduced in extreme cold.
• To use the radio in very cold weather, periodically warm it under your coat if
possible.
• An optional remote speaker / microphone allows keeping the radio under
your coat while transmitting and receiving.
7. • To “talk” with each other, radios must be programmed identically for Quiet
Call code, as well as frequency. Each code is unique; radios respond only
to the code programmed.
• Press and hold both volume buttons at the same time.
A single
beep indicates Quiet Call squelch is on.
A double
beep indicates Quiet Call squelch is off.
CHART
If you have trouble operating the handheld, review the Controls & Operation, pages 3 through 8.
If you think the radio is malfunctioning, check the list below.
Problem Possible Solutions
GENERAL
•
Make sure that the batter
y
is installed correctl
y,
as shown in FIG-7.
p
a
g
e 14.
The radio does not work at all.
•
Rechar
g
e or re
p
lace the batter
y
.
(
See
p
a
g
es 14 & 15.
)
Operating features do not work
exactly as expected.
• The radio has been dealer programmed for customized operation. (Consult dealer.)
•
Move to a different location.
(
See Note 2.
)
Reception is poor.
•
Confirm the
p
ro
p
er antenna is connected to the radio.
(
See
p
a
g
e 3, Antenna
)
•
Turn off Quiet Call
(
coded
)
s
q
uelch.
(
See Note 3.
)
•
Ensure radio receives on the same fre
q
uenc
y
as the caller transmits.
(
See Note 4.
)
You cannot hear calls from
other radios.
•
Rechar
g
e the batter
y
.
(
See Note 1.
)
•
Make sure that your radio transmits on the receive frequency of the radio(s) you
want to call. (See Note 4.)
Your calls cannot be heard in
other radios.
•
Rechar
g
e the batter
y
.
BATTER
Y
•
Review batter
y
char
g
in
g
instructions
,
p
a
g
e 15.
•
Conserve the batter
y
.
(
See Note 5.
)
•
If the radio is used in extreme cold, warm the radio under
y
our coat.
(
See Note 6.
)
Battery loses charge sooner
than expected.
•
Re
p
lace the batter
y
; see FIG-7,
p
a
g
e 14.
(
See Note 1.
)
ERROR TONES
An error tone sounds when the
radio is first switched on.
• See “Error Tones” on page 5
•
Refer to ‘Transmitter Time-Out,”
p
a
g
e 6.
An error tone occurs while
transmitting.
•
Refer to “Rechar
g
e Batter
y
Alert,”
p
a
g
e 6.
QUIET CALL
•
Make sure that the channel is
p
ro
g
rammed with Quiet Call.
You cannot screen out calls
from users outside of your Quiet
Call group.
• Activate coded squelch. (See Note 7.)
You cannot hear Quiet Call
messages while in Quiet Call
(coded) squelch.
• Confirm that the channel is programmed to detect the same code as the calling
radio(s) transmits. (See Note 7.)
Others in your Quiet Call group
cannot hear your Quiet Call
messages.
• Verify that you transmit the same code as the radio(s) you call are programmed to
detect. (See Note 7.)
Související produkty a manuály pro Obousměrná rádia Ritron " 6 " SERIES OUTPOST
Obousměrná rádia Ritron RQX-451 Uživatelský manuál
(21 stránky)
(21 stránky)
© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.030 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce